What a Mini-Split Installation Involves
The work starts with load math for the room, not a guess. We size the head to the space in BTU terms, then pick a mounting spot that moves air where you actually sit. A small penetration through the exterior wall carries the refrigerant lines, the drain and the control wiring back to the outdoor unit. We set the condenser on a pad or wall bracket, run the line set, pull a vacuum, commission the charge and check the drain falls the right direction. Then we walk you through the remote and the modes.
What We Check Before and During Install
We check the electrical capacity at your panel, because most mini-splits want a dedicated circuit. We look at wall construction, insulation and window exposure, since a west-facing room in our summers behaves nothing like a north bedroom. We confirm condensate has somewhere to go that will not stain drywall in three years. During startup we verify line-set length against the charge, measure supply and return air temperatures, and watch how the unit handles humidity, which matters more here than raw cooling capacity.
How We Decide a Ductless System Is the Right Call
Ductless makes sense when there is no duct path, when the duct path runs through an attic that hits punishing temperatures, or when one or two rooms are the only problem. It also fits sunrooms, additions, workshops and upstairs spaces that a central system was never sized for. If your ducts are intact and the whole house is uneven, we will say so and look at the ductwork or the central equipment instead. We would rather fix the real cause than sell you a head on the wall.
Other AC installation work
What every visit includes
You approve a written quote first
Covering 55 cities across Arkansas, Louisiana, Missouri and 4 more.You reach a person, not a menu
Open 7 days, 8:00 AM to 5:00 PM CT.Independent of every manufacturer
Carrier, Trane, Lennox, Goodman and more. We are not an authorized dealer for any of them.Ductless Mini-Split Installation — quick answers
Can one mini-split cool my whole house?
Usually not from a single head. Air will not travel around corners and down halls on its own. A multi-zone system with a head in each problem room works better. We will map that out during the visit.
Will a mini-split heat as well as cool?
Yes. Most units we install are heat pumps and run in reverse for heating, which covers a lot of our winter. In hard cold snaps, homes with a gas furnace still lean on the furnace for the main living space.
How much wall does the indoor head take up?
A typical wall head is a few feet wide and shallow, mounted high on the wall. Ceiling cassette and floor-mounted options exist if wall space is tight. We show you placement choices before anything is cut.
How it works
- Step 1
Tell us the symptom
Call or fill out the quote form and describe what the system is doing. Warm air, short cycling, water on the floor, a smell, a noise. That detail tells us what parts to load on the truck.
- Step 2
We diagnose on site
A technician checks the thermostat, the electrical side, airflow through the filter and coil, refrigerant behaviour and the ductwork. You hear what we found in plain language before anything gets replaced or repaired.
- Step 3
You approve the fix
We explain the repair, what it costs and what happens if you wait a season. Nothing gets done without your go-ahead, and we tell you honestly when a repair no longer makes sense.
- A real person answers
- Open 7 days
- Written quote before work starts
Why homeowners call us
- We know humid-climate systemsAcross the region the real enemy is moisture. Systems here run long hours pulling water out of the air, and that shows up as frozen coils, clogged drains and mildew smells. We diagnose for humidity, not just temperature.
- Mixed gas and heat pump workPlenty of homes we visit run a heat pump with gas backup, and the two have to hand off cleanly. We troubleshoot both sides, including defrost boards, reversing valves, ignitors and heat exchanger concerns.
- Attic ductwork is our daily breadMid-century homes often have ducts running through attics that hit brutal temperatures. Crushed runs, disconnected boots and leaking joints steal cooling before it reaches the room. We find them instead of blaming the equipment.
- Repair before replaceA capacitor, a contactor, a blower motor or a clogged drain line fixes a lot of the calls we take. We would rather fix what you have and tell you plainly when the numbers stop working.
- All major brands, gas & electricFrom Carrier and Trane to Lennox, Goodman, Rheem and Bryant, serviced independently.
- Straight answersNot worth fixing? We say that out loud, and often it saves you the visit fee.
Ductless Mini-Split Installation
Ready to book ductless mini-split installation?
Describe the system and your ZIP. The written quote comes before any work.
- A real person answers
- Open 7 days
- Written quotes
- All major brands
- Gas & electric
Rather not call? Get a free quote →
